Correct Jeep Wrangler TJ or LJ rear suspension geometry with a JKS Rear Track Bar Relocation Bracket. The design compensates for improper track bar alignment / orientation after adjusting rotation of the axle housing. Requires 2.0 to 6.0 in. suspension lift. Correction improves driveline angles after suspension has been lifted and a CV-type driveshaft installed. The heavy duty steel bracket attaches directly to factory track bar mount on your Jeep's axle housing. It relocates the mounting point 4.0 in. higher to reduce track bar operating angle and improve handling at speed. Eliminates binding and premature bushing wear. Minimizes risk of track bar failure. Protective powder coat finish resists corrosion.
- Heavy-duty reinforcement bracket attaches directly to factory track bar mount on axle housing
- Angled design corrects geometry on lifted vehicles with rotated axle housing or CV-type driveshaft
- Premium steel construction is laser cut, formed and folded for maximum strength
- Economical bolt-on solution minimizes risk of track bar failure on the trail
- Protective powder coat finish resists corrosion
Requires 2.0 in. suspension lift or greater.
Vehicle must be equipped with CV-type driveshaft.
Not compatible with right hand drive vehicles.
All JKS products are protected by a limited lifetime warranty to ensure they are free from manufacturer defects in material and workmanship so you can go with confidence knowing your JKS parts are covered.
