The secret to cooling is 2 things; Fluid volume and fluid flow rate.
Imagine this. Your intercooler fluid passes through the intercooler slowly and absorbs the hot boosted air, then the surface temp of the intercooler increases and so do the intake temps.
Now let’s smash the fluid through as fast as possible, as that fluid isn’t exposed to the heat for as long the surface temp of the intercooler stays colder and so do the intake temps.
Without a reservoir tank your entire fluid volume is doing 1 full lap of the system every 2 seconds, meaning every 2 seconds your entire fluid volume is multiplying in temperature. With the tank fitted you have well over a minute worth of fluid volume. This then results in a stable “constant” fluid temp for the entire time you are under wide open throttle which keeps your intake temps way down.
It also provides instant recovery after you get off the throttle as the unused still freezing cold fluid rushes through and knocks your temps straight back down. Allowing you to do back-to-back to back hits.
Combined with a Tank Specific CWA400 intercooler pump you are able to achieve both incredible fluid flow and fluid volume to match the flow.
This tank cannot be used with the CWA400 pump that is sold separately, tank and pump must be ordered at the same time because the tanks are specifically made to fit the pump.
Ensure you leave an air gap at the top of the tank, do not fill it entirely.
Install:
The tank utilizes mounting points that align with all factory holes, no drilling is required.
The tank comes configured to work with your factory blower coolant hard lines.
Simply remove your factory pump and brackets and put the tank in place and wire up the pump.
Foam Insulation
We will insulate the tank for you, the foam will stop condensation forming and also reduce the energy loss of the cold fluid to the ambient environment. This helps you stay colder and keeps your car racetrack safe.
- Reservoir tank suits 2015+ Challenger & Charger
- 100% made in the USA
- Adds 3.875gal to system capacity
- Designed to work while being paired with our chiller system
- Uses factory mounting points, no drilling is required
