There is nothing like the aggressive look of a car with the right stance! Over time, stock springs sag, get rusty, and simply wear out. BMR Suspension believes the right springs go beyond looks—your Challenger needs to perform, too! BMR springs are manufactured from chrome silicon high-tensile spring wire, and are cold wound on a CNC coiling machine. The CNC coiling head can adjust the spring diameter in real time to ensure that every spring is exactly the same. This guarantees that your right spring matches your left spring. Every BMR spring is compressed solid at the factory, not once, but twice. This gives the spring its permanent set and guarantees no sag. BMR springs are stress-relieved at 750 degrees F, ensuring most stresses induced during the winding process are eliminated. All springs are then shot-peened to eliminate residual surface stresses. Many spring manufacturers skip this step, but BMR insists on this operation as part of our spring manufacturing process. Every spring is computer tested as the last step, every spring! not just a sample from each batch. Each spring is loaded in the spring tester at the factory, then compressed and the CNC load cell measures the force for a variety of spring lengths. This allows BMR to offer a LIFETIME WARRANTY against spring sag.
Blending aesthetics and performance, BMR has designed the SP110 for the street performance crowd who want to use their cars in a variety of applications. These springs will lower your V8-equipped Dodge by 1.25 inches in the front. The 280 lb/in (front) linear spring rate offers plenty of support, keeping the body flat and level in the corners, while remaining soft enough for a comfortable ride on any road. The lowered stance and increased spring rate decreases body roll and gives you a lower center of gravity for increased driver control in aggressive cornering situations. Combine this with BMR adjustable sway bars and you have the ultimate in handling and performance. When performance and looks are a must, rely on BMR Suspension!
SP111 Lowering Springs will lower Hellcat, Demon, and Redeye Challengers by approximately 1.5 inches in the front.
BMR Suspensions SP111 lowering springs are available in red powder coat for long-lasting good looks. Installation time is about 1-2 hours. Proudly made in the U.S.A.
- Dramatically improves handling and ride quality
- Lower center of gravity
- Decreased body roll
- Improved driver control
- 280lb front spring rates
- Manufactured from chrome silicon high-tensile spring wire
- Cold wound on a CNC Coiling Machine to exact specifications
- Lifetime warranty against spring sag
- Stress-relieved at 750 degrees F
- Shot-peened
- Computer tested for accurate height and spring rate
- Made in the U.S.A.
