null

BBK 40150 1-3/4" Shorty Headers Silver Ceramic for 19-24 RAM 1500 5.7L VVT HEMI

Product Code: bbk40150
(No reviews yet) Write a Review
Share:
MSRP: $619.99
$569.99
UPC:
197975401502
High Horse Performance is Veteran Owned & Operated
Description

Increased Exhaust Flow for More Power
Improve the power and sound from your 2019 and up RAM 5.7L Hemi with these polished ceramic coated BBK Performance shorty headers. BBK Performance shorty headers will increase your exhaust flow giving you additional horsepower and torque. BBK shorty headers will give your Hemi powered Ram a throaty exhaust note. The durable ceramic coated finish holds in heat, reducing under hood temperatures and improving power.

Top Quality Construction
BBK Performance shorty headers are made from 1-3/4" CNC-machined mandrel bent tubing with 3/8" thick die-stamped flanges. The large diameter primary tube design creates unrestricted airflow for ultimate horsepower gains. These headers are pressure tested to ensure leak free performance.

Installation
These Ram 5.7 shorty headers are designed as a direct bolt on. For use with factory or any aftermarket mid pipes. Kit includes new gaskets and hardware.

  • Increase of 15 Horsepower and 20 ft lbs of Torque is Typical
  • Increased Exhaust Flow for More Power
  • 1-3/4" Primaries for Maximum Flow
  • 16 Gauge Steel Tubing and 3/8" Thick Flanges
  • Direct Bolt-On for Easy Installation
  • For Use With Factory or Aftermarket Mid Pipes
  • Gaskets and Hardware Included
  • Durable Polished Silver Ceramic Finish

Installation Instructions

IMPORTANT WARRANTY INFORMATION:
Installing ANY type of header wrap will VOID your BBK Warranty

"Heat Protection"

Use supplied heat wrap, wire, zip ties to protect hoses and wires from resting on header tubes. Use zip ties to run thru coil pack mounts to bring coolant hoses up from header tubes and some models just remove factory plastic valve cover mounts on coolant lines for adequate clearance. When wrapping any hoses or wires for protection cut heat wrap amount needed for area to protect and then use supplied stainless wire strips and cut into sections and twist-tie in place. "Pics" Above are for later cable driven model transmissions remove factory cable bracket and install BBK supplied bracket as shown in pics and make sure to not overtighten hose clamp. This gives the transmission cable more clearance from header/heat protection.

Emissions Information
This part is NOT C.A.R.B Approved and cannot be installed for use on any emission-controlled vehicle in California. It cannot be sold or shipped to any California resident or addresses